Steam Expansion Through a Pressure Reducing Station

Steam expansion through a pressure reducing valve is a throttling process. It is adiabatic, because the steam passes through the valve too quickly to exchange heat with its surroundings, and it does no work. Since the inlet and outlet velocities are comparable, the steam enthalpy is the same on both sides of the valve. The downstream steam condition is therefore fully set by the upstream condition (pressure, and temperature or quality) and by the downstream pressure. The expansion is irreversible: entropy increases and the steam ends up drier, or superheated, at a lower temperature. The calculator below finds the outlet steam temperature and condition.

Steam leaving a boiler is not perfectly dry: it carries fine water droplets. Depending on the boiler’s steam separation technology, its quality is most often between 95 and 99%. This must be taken into account at the valve inlet.

Step 1

Steam upstream of the valve

Steam condition
Step 2

Pressures and conditions

Atmospheric pressure:
Results

Downstream steam

Example: 125 psig, 95% quality → 80 psig

Temperature–entropy diagram

Saturation curveUpstream and downstream isobarsConstant-enthalpy expansion

Worked example

Steam at 125 psig and 95% quality is reduced to 80 psig. Its enthalpy, 1,149.9 BTU/lb, stays the same: the steam leaves at 323.9 °F, at saturation, with 95.9% quality. Its specific volume increases by 46%.

Assumptions: Adiabatic expansion with no work and no significant change in kinetic energy; steam properties from the IAPWS-IF97 formulation; atmospheric pressure of 14.696 psia, adjustable for the site.

Frequently asked questions

Why is enthalpy conserved in a pressure reducing valve?

The valve exchanges no significant heat with its surroundings and does no work, and the upstream and downstream velocities are comparable. The energy balance then reduces to upstream h = downstream h.

Why does the temperature drop after the valve?

At a lower pressure, the saturation temperature is lower. With the same enthalpy, the steam settles at this new saturation temperature, or slightly above if it leaves superheated.

Should upstream steam quality be taken into account?

Yes. Steam at 95% carries 5% entrained water. During the expansion, part of this water evaporates: the quality rises slightly, for example from 95% to 95.9% between 125 and 80 psig, but the steam remains wet downstream. Dry steam upstream would instead leave slightly superheated. Enter the measured or estimated quality, or 100% for dry saturated steam.

Why does the steam volume increase?

The specific volume of steam increases as pressure drops. Piping downstream of the valve must therefore be larger to keep a reasonable velocity.

Related calculators

Written and reviewed by Alex Lapierre, P.Eng. (ing.), MBA, 30+ years in industrial thermal energy. Updated November 17, 2026.

Scroll to Top